The use of electric pipe unclogging machine, that is, the person will be special unclogging spring through the pipe unclogging machine, and then reach the location of the pipe blockage, press down to tighten the spring handle, turn on the power supply, through the unclogging spring in the pipeline gradually thrown forward to unclog the blocked pipe. There are two ports on the pipe unclogger, one for inlet and one for outlet. The one with the roller hanging on the newly opened unclogging machine is the inlet of the unclogging spring. The one with the automatic head on the opposite side is the outlet of the unclogging spring. Many people mistakenly think that the operation of the electric pipe unclogging machine is very complicated, in fact, it is not, in fact, a layer of a poke to break the windowpaper. If you can see for yourself what happens when someone else uses it, you won't have any more doubts as soon as you do.
To use the 16mm thick spring in the basket, you need to remove the roller hanging on the machine. The spring is threaded through the inlet where the roller was hanging, and out the outlet with the automatic head, and the cutter head is installed to unclog the clogged position of the downspout when it reaches in. Since the entire unclogging spring that is connected to the machine will be thrown around when the machine is turned on, be careful not to leave half of the unclogging spring that is mounted on the machine in the machine and half in the iron basket! The normal procedure is to continue the unclogging spring outside the inlet of the unclogging machine according to the length of the unclogging specifically required. Considering that household unclogging machines are usually equipped with only 12 meters of unclogging spring. So you just need to take the whole spring out of the basket when you turn on the machine.
You can use an automatic head when using a 16mm thick spring. However, it is recommended not to use it for first time users who have no experience in using it and do not know how to use it. It is recommended to send the spring directly into the pipe by hand, which is not troublesome. Because the automatic head is a small iron tongue stuck in the spring to force the spring forward and backward propulsion device. Improper use is very easy to stretch the spring. Especially the movement to the spring and spring joints, must be pulled up beforehand the automatic head of the small iron tongue, otherwise, there will be problems. Therefore, the manufacturer of the automatic head in the position of the dredging machine are labeled: “Where the use of automatic head to stretch the soft spring of the responsibility of its own” attention to the prompt.
The use of roller 10mm fine spring, can not use the automatic head, spring in and out by hand from the manual hanging on the machine roller bin free pull out or advance on the line. However, it is important not to pull the whole spring completely out of the roller! So, in fact, the fine spring is only suitable for unblocking the return bend of the sink at a distance of about 2 meters at most.